TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-14 Steering Control
2. Using the MSD (WP 0006), select 1472-14 Code Active - Repeat
Position Sensor #2 Special
Implement 120M and verify 1472- troubleshooting code from the
Instruction - Continued
14 is not active.
beginning.
1472-14 Code Not Active -
Troubleshooting complete.
Test Step 5. Test for Open Cab
Upper Wiring Harness to Imple-
ment ECM.
1. Remove jumper wire between P-
C51 terminal 7 and terminal 4
(WP 0009, Figure 118).
2. Connect jumper wire between P-
C51 terminal 7 and terminal 8
(WP 0009, Figure 118).
3. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between cab lower wir-
Replace transmission ECM (WP
ing harness connector P-C39
0137).
(WP 0009, Figure 70) terminal 48
Remove jumper wire from P-C51
and P-C41 (WP 0009, Figure 68)
terminal 7 and terminal 8 (WP 0009,
terminal 45.
Figure 118).
Resistance should be less than
Connect the cab lower wiring harness
5.0 ohms.
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 4.
0027-93
