TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-14 Steering Control
4. Using digital multimeter, measure
Voltage OK (11.8 to 12.3 Volts) -
Position Sensor #2 Special
voltage between P-C51 terminal 7
Sensor signal circuit, transmission
Instruction - Continued
(WP 0009, Figure 118) and termi-
and implement ECM OK. Replace LH
nal 8 (ground).
joystick (WP 0282).
Voltage should be 11.8 to 12.3 volts.
Proceed to step 5.
Voltage Not OK - Sensor signal
circuit shorted to ground or
transmission or implement ECM bad,
proceed to Test Step 3.
5. Using the MSD (WP 0006), select 1472-14 Code Active - Repeat
Implement 120M and verify 1472- troubleshooting code from the
beginning.
14 is not active.
1472-14 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
3. Disconnect the rear chassis wir-
ing harness connector FA-C21
(WP 0009, Figure 124) from
transmission ECM J2 (WP 0009,
Figure 112).
4. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J-2 (WP 0009, Figure 71)
(WP 0268).
5. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
6. Connect jumper wire between P-
C51 terminal 7 and terminal 4
(WP 0009, Figure 118).
0027-91
