TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-14 Steering Control
System Response:
Position Sensor #2 Special
ECM will log a diagnostic code and a
Instruction
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for Other Codes.
1. Connect MSD (WP 0006), select
Trans/chassis 120M and verify
1472-14 is active.
2. Check for Active code 1472-14
Code 1472-14 Active on Both
Implement 120M ECM (WP
Trans/Chassis and Implement
0006).
ECMs - Proceed to Test Step 2.
Code 1472-14 Active on Trans/
Chassis ECM Only - Proceed to Test
Step 3.
Test Step 2. Test for Signal Voltage
at LH Joystick.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C51 (WP
0009, Figure 118) from LH joy-
stick connector J-1 (WP 0009,
Figure 119) (WP 0282).
3. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
0027-90
