TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
c.
Linkage bent or damaged.
Linkage Bent or Damaged - Replace
0615-02 Machine Articula-
articulation angle position sensor 1
tion Angle Sensor Data
(left) linkage and perform adjustment
Erratic, Intermittent or Incor-
(WP 0257).
rect - Continued
Proceed to step 2.
Sensor and Linkage OK - Proceed to
Test Step 3.
2. Using MSD (WP 0006), verify
0615-02 Code Active - Proceed to
0615-02 is active for the transmis-
Test Step 3.
sion ECM or the Implement 1
0615-02 Code Not Active -
ECM.
Troubleshooting complete.
Test Step 3. Check 8 Volt Supply
Circuit From The Implement 1 ECM.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect secondary steering
harness connector AT-C3 (WP
0009, Figure 144) from articula-
tion angle position sensor 1 (left)
(WP 0009, Figure 145) (WP
0257).
3. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
Voltage 7.5 to 8.5 Volts - Proceed to
voltage between harness connec-
Test Step 4.
tor AT-C3 (WP 0009, Figure 144)
Voltage Less Than 7.5 Volts -
terminal A and machine ground.
Proceed to step 5.
Voltage should be 7.5 to 8.5 volts.
5. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
6. Remove rear bulkhead cover
plate (WP 0266).
7. Disconnect rear chassis wiring
harness connector FA-C23 (WP
0009, Figure 17) from cab lower
wiring harness connector P-C71
(WP 0009, Figure 18).
0027-3