TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-08 Machine Articula-
8.
Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
tion Angle Sensor #2 Abnor-
continuity between rear chassis
Replace transmission ECM (WP
mal Frequency, Pulse Width
harness connector FA-C20 (WP
0137).
or Period - Continued
0009, Figure 113) terminal 44 and
Remove jumper wire from AT-C4 (WP
terminal 45.
0009, Figure 122) terminal A and ter-
Resistance should be less than
minal B.
5.0 Ohms.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position sen-
sor 2 (right) (WP 0009, Figure 123)
(WP 0257).
Proceed to step 11.
Resistance More Than 5.0 Ohms -
Proceed to step 9.
9. Disconnect rear chassis harness
connector FA-C5 (WP 0009, Fig-
ure 111) from secondary steering
wiring harness AT-C1 (WP 0009,
Figure 110) (WP 0186).
10. Using digital multimeter, test for
Continuity - Replace rear chassis
continuity between secondary
wiring harness (WP 0188).
steering wiring harness AT-C1
Remove jumper wire from AT-C4 (WP
(WP 0009, Figure 110) terminal 8
0009, Figure 122) terminal A and ter-
and terminal 9.
minal B.
There should be no continuity.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position sen-
sor 2 (right) (WP 0009, Figure 123)
(WP 0257).
Proceed to step 11.
No Continuity - Replace secondary
steering wiring harness (WP 0186).
Connect rear chassis harness con-
nector FA-C20 (WP 0009, Figure 113)
to transmission ECM J1 (WP 0009,
Figure 112) (WP 0137).
Proceed to step 11.
11. Using MSD (WP 0006). Select
2252-08 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
2252-08 is active.
diagnostic code.
2252-08 Code Not Active - Trouble-
shooting complete.
0020-138