TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-04 Machine Articula-
Test Step 5. Check for Shorted Cab
tion Angle Sensor #2 Volt-
Lower Wiring Harness.
age Below Normal -
1. Using digital multimeter, test for
Continuity - Proceed to Test Step 6.
Continued
continuity between cab lower wir-
No Continuity - Proceed to step 2.
ing harness connector P-C39
(WP 0009, Figure 70) terminal 17
and machine ground. There
should be no continuity.
2. Using MSD (WP 0006), verify
2252-04 was active for the trans-
2252-04 was active for the Trans-
mission ECM only - Replace trans-
mission ECM or the Implement 1
mission ECM (WP 0137).
ECM.
Proceed to step 3.
2252-04 was active for the imple-
ment 1 ECM only - Replace imple-
ment 1 ECM (WP 0268).
Proceed to step 3.
2252-04 was active for the trans-
mission ECM and the implement 1
ECM - Replace transmission ECM
(WP 0137) and implement 1 ECM
(WP 0268).
Proceed to step 3.
3. Using MSD (WP 0006). Select
2252-04 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
2252-04 is active.
diagnostic code.
2252-04 Code Not Active - Trouble-
shooting complete.
0020-134