TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-13 Machine Articula-
a. Linkage securely connected
Linkage Loose or Sensor Not
tion Angle Sensor #2 Out of
to machine and to sensor.
Secure - Perform installation and
adjustment procedures for articula-
tion angle position sensor 2 (right)
(WP 0257).
Proceed to step 2.
b. Remove articulation angle
Sensor Damaged - Replace articula-
position sensor 2 (right) and
tion angle position sensor 2 (right)
visually inspect sensor hous-
(WP 0257).
ing, and harness connector
Proceed to step 2.
for damage (WP 0257).
c.
Linkage bent or damaged.
Linkage Bent or Damaged - Replace
articulation angle position sensor 2
(right) linkage and perform adjustment
(WP 0257).
Proceed to step 2.
Sensor and Linkage OK - Proceed to
Test Step 3.
2. Using MSD (WP 0006). Select
2252-13 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
2252-13 is active.
diagnostic code.
2252-13 Code Not Active - Trouble-
shooting complete.
Test Step 3. Check Sensor.
1. Verify articulation angle position
Articulation Angle Position Sensor
sensor is within specifications
OK - Proceed to Test Step 4.
refer to Adjustment in WP 0257.
Articulation Angle Position Sensor
Needs Adjustment - Adjust sensor
as directed (WP 0257).
Proceed to step 2.
2. Using MSD (WP 0006). Select
2252-13 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
2252-13 is active.
diagnostic code.
2252-13 Code Not Active - Trouble-
shooting complete.
Test Step 4. Calibrate Sensor.
1. Calibrate articulation angle posi-
Articulation Angle Position Sensor
Cannot Be Calibrated - Perform cali-
bration procedure again. If sensor
WP 0257.
cannot be calibrated, replace articula-
tion angle position sensor (WP 0257).
Articulation Angle Position Sensor
Calibrated OK - Proceed to step 2.
0020-141