TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-04 Machine Articula-
Test Step 4. Check for Shorted Sec-
tion Angle Sensor #2 Volt-
ondary Steering Wiring Harness.
age Below Normal -
1. Disconnect rear chassis harness
Continued
connector FA-C5 (WP 0009, Fig-
ure 111) from secondary steering
wiring harness AT-C1 (WP 0009,
Figure 110) (WP 0186).
2. Using digital multimeter, test for
Continuity - Replace secondary
continuity between secondary
steering wiring harness (WP 0186).
steering wiring harness AT-C1
Connect rear chassis harness con-
(WP 0009, Figure 110) terminal
nector FA-C20 (WP 0009, Figure 113)
10 and machine ground. There
to transmission ECM J1 (WP 0009,
should be no continuity.
Figure 112) (WP 0137).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Connect rear chassis harness con-
nector FA-C21 (WP 0009, Figure 124)
to transmission ECM J2 (WP 0009,
Figure 112).
Proceed to step 3.
No Continuity - Replace rear chassis
wiring harness (WP 0188).
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position sen-
sor 2 (right) (WP 0009, Figure 123)
(WP 0257).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Proceed to step 3.
3. Using MSD (WP 0006). Select
2252-04 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
2252-04 is active.
diagnostic code.
2252-04 Code Not Active - Trouble-
shooting complete.
0020-133
