TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-08 Machine Articula-
c.
Linkage bent or damaged.
Linkage Bent or Damaged - Replace
tion Angle Sensor #2 Abnor-
articulation angle position sensor 2
mal Frequency, Pulse Width
(right) linkage and perform adjustment
or Period - Continued
(WP 0257).
Proceed to step 2.
Sensor and Linkage OK - Proceed to
Test Step 3.
2. Using MSD (WP 0006), verify
2252-08 Code Active - Proceed to
2252-08 is active for the transmis-
Test Step 3.
sion ECM or the Implement 1
2252-08 Code Not Active - Trouble-
ECM.
shooting complete.
Test Step 3. Check 8 Volt Supply
Circuit.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect secondary steering
harness connector AT-C4 (WP
0009, Figure 122) from articula-
tion angle position sensor 2 (right)
(WP 0009, Figure 123) (WP
0257).
3. Turn battery disconnect switch
and ignition switch to the ON posi-
tion (TM 5-3805-293-10).
4. Using digital multimeter, test for
Voltage Between 7.5 and 8.5 Volts -
voltage between harness connec-
Proceed to Test Step 4.
tor AT-C4 (WP 0009, Figure 122)
Voltage Less Than 7.5 Volts - Pro-
terminal A and terminal B.
ceed to step 5.
Voltage should be 7.5 to 8.5 volts.
5. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
6. Disconnect rear chassis harness
connector FA-C20 (WP 0009, Fig-
ure 113) from transmission ECM
J1 (WP 0009, Figure 112) (WP
0137).
7. Connect jumper wire between AT-
C4 (WP 0009, Figure 122) termi-
nal A and terminal B.
0020-137
