TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-08 Machine Articula-
8.
Using MSD (WP 0006), verify
2252-08 was active for the trans-
tion Angle Sensor #2 Abnor-
2252-08 was active for the Trans-
mission ECM only - Replace trans-
mal Frequency, Pulse Width
mission ECM or the Implement 1
mission ECM (WP 0137).
or Period - Continued
ECM.
Proceed to step 9.
2252-08 was active for the imple-
ment 1 ECM only - Replace imple-
ment 1 ECM (WP 0268).
Proceed to step 9.
2252-08 was active for the trans-
mission ECM and the implement 1
ECM - Replace transmission ECM
(WP 0137) and implement 1 ECM
(WP 0268).
Proceed to step 9.
9. Using MSD (WP 0006). Select
2252-08 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
2252-08 is active.
diagnostic code.
2252-08 Code Not Active - Trouble-
shooting complete.
2252-13 Machine Articula-
System Response:
tion Angle Sensor #2 Out of
ECM will log a diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 2252-13
is Active.
1. Connect MSD (WP 0006). Select
2252-13 Code Active - Proceed to
Trans/Chassis 120M and verify
Test Step 2.
2252-13 is active for the
2252-13 Code Not Active - Trouble-
transmission ECM or the
shooting complete.
Implement 1 ECM.
Test Step 2. Inspect Sensor and
Linkage.
1. Inspect articulation angle position
sensor 2 (right) (WP 0009, Figure
123) and linkage for the following:
0020-140
