TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-02 Machine Articula-
3.
If not installed, install a jumper
tion Angle Sensor #2 Data
wire between harness connector
Erratic, Intermittent or Incor-
AT-C4 (WP 0009, Figure 122) ter-
rect - Continued
minal B and terminal C.
4. Disconnect cab lower wiring har-
ness connector P-C39 (WP 0009,
Figure 70) from Implement 1 ECM
J2 (WP 0009, Figure 71) (WP
0268).
5. Disconnect rear chassis harness
connector FA-C20 (WP 0009, Fig-
ure 113) from transmission ECM
J1 (WP 0009, Figure 112) (WP
0137).
6. Disconnect rear chassis harness
connector FA-C21 (WP 0009, Fig-
ure 124) from transmission ECM
J2 (WP 0009, Figure 112).
7. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
continuity between rear chassis
ceed to Test Step 7.
harness connector FA-C21 (WP
Resistance More Than 5.0 Ohms -
0009, Figure 124) terminal 17 and
Proceed to Test Step 6.
connector FA-C20 (WP 0009, Fig-
ure 113) terminal 45.
Resistance should be less than
5.0 Ohms.
Test Step 6. Check for Open Sec-
ondary Steering Wiring Harness.
1. Disconnect rear chassis harness
connector FA-C5 (WP 0009, Fig-
ure 111) from secondary steering
wiring harness AT-C1 (WP 0009,
Figure 110) (WP 0186).
0020-120