TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-02 Machine Articula-
Test Step 7. Check for Open Cab
tion Angle Sensor #2 Data
Lower Wiring Harness.
Erratic, Intermittent or Incor-
1. Remove jumper wire from har-
rect - Continued
ness connector AT-C4 (WP 0009,
Figure 122) terminal B and termi-
nal C.
2. Install a jumper wire between har-
ness connector AT-C4 (WP 0009,
Figure 122) terminal C and
machine ground.
3. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
continuity between cab lower wir-
ceed to step 4.
ing harness connector P-C39
Resistance More Than 5.0 Ohms -
(WP 0009, Figure 70) terminal 17
Proceed to Test Step 8.
and machine ground.
Resistance should be less than
5.0 Ohms.
4. Using the MSD (WP 0006), verify
2252-02 was active for the trans-
2252-02 was active for the Trans-
mission ECM only - Replace trans-
mission ECM or the Implement 1
mission ECM (WP 0137).
ECM.
Proceed to step 5.
2252-02 was active for the imple-
ment 1 ECM only - Replace imple-
ment 1 ECM (WP 0268).
Proceed to step 5.
2252-02 was active for the trans-
mission ECM and the implement 1
ECM - Replace transmission ECM
(WP 0137) and implement 1 ECM
(WP 0268).
Proceed to step 5.
5. Using MSD (WP 0006). Select
2252-02 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
2252-02 is active.
diagnostic code.
2252-02 Code Not Active - Trouble-
shooting complete.
Test Step 8. Check for Open Rear
Chassis Wiring Harness.
1. Disconnect rear chassis harness
connector FA-C22 (WP 0009, Fig-
ure 47) from cab lower wiring har-
ness P-C69 (WP 0009, Figure 46)
(WP 0188).
0020-122
