TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-03 Machine Articula-
5. Turn ignition switch and battery
tion Angle Sensor #2 Volt-
disconnect switch to the OFF
age Above Normal -
position (TM 5-3805-293-10).
Continued
6. Disconnect rear chassis harness
connector FA-C20 (WP 0009, Fig-
ure 113) from transmission ECM
J1 (WP 0009, Figure 112) (WP
0137).
7. Connect jumper wire between AT-
C4 (WP 0009, Figure 122) termi-
nal A and terminal B.
Resistance 5.0 Ohms or Less -
Replace transmission ECM (WP
harness connector FA-C20 (WP
0137).
0009, Figure 113) terminal 44 and
Remove jumper wire from AT-C4 (WP
terminal 45.
0009, Figure 122) terminal A and ter-
minal B.
5.0 Ohms.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position sen-
sor 2 (right) (WP 0009, Figure 123)
(WP 0257).
Proceed to step 11.
Proceed to step 9.
9. Disconnect rear chassis harness
connector FA-C5 (WP 0009, Fig-
ure 111) from secondary steering
wiring harness AT-C1 (WP 0009,
Figure 110) (WP 0186).
0020-125