TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-02 Machine Articula-
Test Step 4. Check Articulation
tion Angle Sensor #2 Data
Angle Position Sensor 2 (Right).
Erratic, Intermittent or Incor-
1. Turn ignition switch and battery
rect - Continued
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Install a jumper wire between har-
ness connector AT-C4 (WP 0009,
Figure 122) terminal A and termi-
nal C.
3. Using MSD (WP 0006), verify
2252-03 Code Active - Proceed to
2252-03 is active.
step 4.
2252-03 Code Not Active - Proceed
to Test Step 5.
4. Remove jumper wire from har-
ness connector AT-C4 (WP 0009,
Figure 122) terminal A and termi-
nal C.
5. Install a jumper wire between har-
ness connector AT-C4 (WP 0009,
Figure 122) terminal B and termi-
nal C.
6. Using MSD (WP 0006), verify
2252-04 Code Active - Replace artic-
2252-04 is active.
ulation angle position sensor 2 (right)
(WP 0257).
Proceed to step 7.
2252-04 Code Not Active - Proceed
to Test Step 5.
7. Using MSD (WP 0006). Select
2252-02 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
2252-02 is active.
diagnostic code.
2252-02 Code Not Active - Trouble-
shooting complete.
Test Step 5. Check for Open Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. If installed, remove jumper wire
from harness connector AT-C4
(WP 0009, Figure 122) terminal A
and terminal C.
0020-119
