TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-02 Machine Articula-
2.
Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
tion Angle Sensor #2 Data
continuity between rear chassis
Replace cab lower wiring harness
Erratic, Intermittent or Incor-
harness connector FA-C22 (WP
(WP 0266).
rect - Continued
0009, Figure 47) terminal 40 and
Remove jumper wire from AT-C4 (WP
machine ground.
0009, Figure 122) terminal C and
Resistance should be less than
machine ground.
5.0 Ohms.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position sen-
sor 2 (right) (WP 0009, Figure 123)
(WP 0257).
Connect rear chassis harness con-
nector FA-C20 (WP 0009, Figure 113)
to transmission ECM J1 (WP 0009,
Figure 112) (WP 0137).
Connect rear chassis harness con-
nector FA-C21 (WP 0009, Figure 124)
to transmission ECM J2 (WP 0009,
Figure 112).
Connect rear chassis harness con-
nector FA-C22 (WP 0009, Figure 47)
to cab lower wiring harness P-C69
(WP 0009, Figure 46) (WP 0188).
Proceed to step 3.
Resistance More Than 5.0 Ohms -
Replace rear chassis wiring harness
(WP 0188).
Remove jumper wire from AT-C4 (WP
0009, Figure 122) terminal C and
machine ground.
Connect secondary steering harness
connector AT-C4 (WP 0009, Figure
122) to articulation angle position sen-
sor 2 (right) (WP 0009, Figure 123)
(WP 0257).
Connect cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to Implement 1 ECM J2 (WP
0009, Figure 71) (WP 0268).
Proceed to step 3.
3. Using MSD (WP 0006). Select
2252-02 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
2252-02 is active.
diagnostic code.
2252-02 Code Not Active - Trouble-
shooting complete.
0020-123
