TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2175-05 Secondary Steer
Test Step 2. Test for Open Rear
Chassis Wiring Harness.
Normal - Continued
1. Disconnect the rear chassis
wiring harness connector FA-C20
(WP 0009, Figure 113) from
transmission ECM J1 (WP 0009,
Figure 112).
2. Connect jumper wire between
front attachment wiring harness
connector U-C39 (WP 0009, Fig-
ure 186) terminal 1 and
terminal 2.
resistance between rear chassis
Transmission ECM faulty, replace
wiring harness connector FA-C20
transmission ECM (WP 0137).
(WP 0009, Figure 113) terminal
Remove jumper wire from front
67 and terminal 54. Resistance
attachment wiring harness connector
should be less than 5.0 Ohms.
U-C39 (WP 0009, Figure 186) termi-
nal 1 and terminal 2.
Connect the front attachment wiring
harness connector U-C39 (WP 0009,
Figure 186) to secondary steering left
0216).
Proceed to step 4.
Proceed to Test Step 3.
4. Using the MSD (WP 0006), select
2175-05 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2175-05 is not active.
2175-05 Code Not Active - Trouble-
shooting complete.
0020-15