TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2113-04 Operator In-Seat
Test Step 4. Test for Open Rear
Switch Voltage Below Nor-
Chassis Wiring Harness.
mal - Continued
1. Using digital multimeter, measure
Continuity - Proceed to Test Step 5.
resistance between rear chassis
No Continuity - Replace transmis-
wiring harness connector FA-C20
sion ECM (WP 0137).
(WP 0009, Figure 113) terminal
Connect the cab lower wiring harness
64 and terminal 70. There should
connector P-C2 (WP 0009, Figure
be no continuity.
184) to operator in-seat switch (WP
0009, Figure 185) (WP 0284).
Proceed to step 2.
2113-04 Code Active - Repeat trou-
2. Using the MSD (WP 0006), select
Trans/chassis 120M and verify
bleshooting code from the beginning.
2113-04 is not active.
2113-04 Code Not Active - Trouble-
shooting complete.
Test Step 5. Test for Shorted Cab
Lower Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) from cab
lower wiring harness connector P-
C69 (WP 0009, Figure 46).
2. Using digital multimeter, measure
Continuity - Cab lower wiring har-
resistance between cab lower wir-
ness is shorted, replace cab lower wir-
ing harness connector P-C69
ing harness (WP 0266).
(WP 0009, Figure 46) terminal 67
Connect the rear chassis wiring har-
and terminal 16. There should be
ness connector FA-C20 (WP 0009,
no continuity.
Figure 113) to transmission ECM J-1
(WP 0009, Figure 112).
Proceed to step 3.
No Continuity - Rear chassis wiring
harness is shorted, replace rear chas-
sis wiring harness (WP 0188).
Connect the cab lower wiring harness
connector P-C2 (WP 0009, Figure
184) to operator in-seat switch (WP
0009, Figure 185) (WP 0284).
Proceed to step 3.
3. Using the MSD (WP 0006), select
2113-04 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2113-04 is not active.
2113-04 Code Not Active - Trouble-
shooting complete.
0020-10
