TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2175-05 Secondary Steer
3. Using the MSD (WP 0006), select
2175-05 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
Normal - Continued
2175-05 is not active.
2175-05 Code Not Active - Trouble-
shooting complete.
2175-06 Secondary Steer
System Response:
ECM will log a diagnostic code and a
Normal
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for Shorted Rear
Chassis Wiring Harness.
1. Connect MSD (WP 0006). Select
Trans/chassis 120M and verify
2175-06 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Disconnect the front attachment
wiring harness connector U-C39
(WP 0009, Figure 186) from sec-
ondary steering left solenoid (WP
0009, Figure 187) (WP 0216).
4. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
0020-18