TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2175-05 Secondary Steer
Test Step 4. Test for Open Front
Left Solenoid Current Below
Attachment Wiring Harness.
Normal - Continued
1. Disconnect the front attachment
wiring harness connector U-C36
(WP 0009, Figure 188) from cab
lower wiring harness connector P-
C151 (WP 0009, Figure 189).
2. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between front attach-
Cab lower wiring harness is open,
ment wiring harness connector U-
replace cab lower wiring harness (WP
C36 (WP 0009, Figure 188) termi-
0266).
nal 3 and terminal 5. Resistance
Remove jumper wire from front
should be less than 5.0 Ohms.
attachment wiring harness connector
U-C39 (WP 0009, Figure 186) termi-
nal 1 and terminal 2.
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J1
(WP 0009, Figure 112).
Connect the front attachment wiring
harness connector U-C39 (WP 0009,
Figure 186) to secondary steering left
solenoid (WP 0009, Figure 187) (WP
0216).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Front attachment wiring harness is
open, replace front attachment wiring
harness (WP 0180).
Connect the rear chassis wiring har-
ness connector FA-C22 (WP 0009,
Figure 47) to cab lower wiring harness
connector P-C69 (WP 0009, Figure
46) (WP 0266).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J1
(WP 0009, Figure 112).
Proceed to step 3.
0020-17