TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-03 Machine Articula-
8. Disconnect cab lower wiring har-
tion Angle Sensor Voltage
ness connector P-C41 (WP 0009,
Above Normal - Continued
Figure 68) from Implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0268).
9. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between harness con-
Proceed to step 10.
nector P-C41 (WP 0009, Figure
Resistance 5.0 Ohms or More -
68) terminal 44 and harness con-
Replace cab lower wiring harness
nector P-C71 (WP 0009, Figure
(WP 0266).
18) terminal 19.
Connect secondary steering harness
Resistance should be less than
connector AT-C3 (WP 0009, Figure
5.0 ohms.
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Proceed to step 12.
10. Disconnect rear chassis wiring
harness connector FA-C5 (WP
0009, Figure 111) from second-
ary steering wiring harness AT-C1
(WP 0009, Figure 110) (WP
0186).
11. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms
continuity between rear chassis
Replace secondary steering wiring
wiring harness connector FA-C23
harness (WP 0186).
(WP 0009, Figure 17) terminal 19
Connect rear chassis wiring harness
and rear chassis wiring harness
connector FA-C23 (WP 0009, Figure
connector FA-C5 (WP 0009, Fig-
17) to cab lower wiring harness con-
ure 111) terminal 5.
nector P-C71 (WP 0009, Figure 18),
Resistance should be less than
and install rear bulkhead cover plate
5.0 ohms.
(WP 0266).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Proceed to step 12.
0017-45