TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
0615-02 Machine Articula-
tion Angle Sensor Data
Harness connector is located behind cab bulkhead cover on right rear
Erratic, Intermittent or Incor-
of cab.
rect - Continued
5. Remove rear bulkhead cover
plate (WP 0266).
6. Disconnect rear chassis wiring
harness connector FA-C22 (WP
0009, Figure 47) from cab lower
wiring harness connector P-C69
(WP 0009, Figure 46) (WP 0188).
7. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between harness con-
Proceed to step 8.
nector P-C69 (WP 0009, Figure
Resistance 5.0 Ohms or More -
46) terminal 26 and harness con-
Replace cab lower wiring harness
nector P-C39 (WP 0009, Figure
(WP 0188).
70) terminal 41.
Connect harness connector P-C39
Resistance should be less than
(WP 0009, Figure 70) to Implement 1
5.0 ohms.
ECM J2 (WP 0009, Figure 71) (WP
0268).
Connect rear chassis wiring harness
connector FA-C22 (WP 0009, Figure
47) to cab lower wiring harness con-
nector P-C69 (WP 0009, Figure 46)
(WP 0188) and install rear bulkhead
cover plate (WP 0266).
Proceed to step 19.
8. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112).
9. Remove jumper wire from har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal B and termi-
nal C.
10. Install a jumper wire between har-
ness connector FA-C21 (WP
0009, Figure 124) terminal 41 and
machine ground.
0017-40
