TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-02 Machine Articula-
11.
Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
tion Angle Sensor Data
continuity between harness con-
Proceed to step 12.
Erratic, Intermittent or Incor-
nector FA-C22 (WP 0009, Figure
Resistance 5.0 Ohms or More -
rect - Continued
47) terminal 26 and machine
Replace rear chassis wiring harness
ground.
(WP 0266).
Resistance should be less than
Connect harness connector P-C39
5.0 ohms.
(WP 0009, Figure 70) to Implement 1
ECM J2 (WP 0009, Figure 71) (WP
0268).
Proceed to step 19.
12. Remove jumper wire from har-
ness connector FA-C21 (WP
0009, Figure 124) terminal 41 and
machine ground.
13. Disconnect rear chassis wiring
harness connector FA-C5 (WP
0009, Figure 111) from second-
ary steering wiring harness AT-C1
(WP 0009, Figure 110) (WP
0186).
14. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
continuity between harness con-
Proceed to step 15.
nector AT-C1 (WP 0009, Figure
Resistance 5.0 Ohms or More -
110) terminal 7 and harness con-
Replace secondary steering wiring
nector AT-C3 (WP 0009, Figure
harness (WP 0186).
144) terminal C.
Connect rear chassis wiring harness
Resistance should be less than
connector FA-C22 (WP 0009, Figure
5.0 ohms.
47) to cab lower wiring harness con-
nector P-C69 (WP 0009, Figure 46),
and install rear bulkhead cover plate
(WP 0266).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Connect harness connector FA-C21
(WP 0009, Figure 124) to transmis-
sion ECM J2 (WP 0009, Figure 112).
Proceed to step 19.
0017-41