TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
0615-02 Machine Articula-
tion Angle Sensor Data
Harness connector is located behind cab bulkhead cover on right rear
Erratic, Intermittent or Incor-
of cab.
rect - Continued
3. Remove rear bulkhead cover
plate (WP 0266).
4. Disconnect rear chassis wiring
harness connector FA-C23 (WP
0009, Figure 17) from cab lower
wiring harness connector P-C71
(WP 0009, Figure 18).
5. Disconnect cab lower wiring har-
ness cab lower wiring harness
connector P-C41 (WP 0009, Fig-
ure 68) from Implement 1 ECM J1
(WP 0009, Figure 69) (WP 0268).
6. Install a jumper wire between har-
ness connector P-C41 (WP 0009,
Figure 68) terminal 44 and termi-
nal 45.
7. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
continuity between harness con-
ceed to step 8.
nector FA-C23 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
17) terminal 4 and terminal 19.
Replace cab lower wiring harness
Resistance should be less than
(WP 0188).
5.0 ohms.
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to articulation angle position sen-
sor 1 (left) (WP 0009, Figure 145)
(WP 0257).
Proceed to step 10.
8. Disconnect rear chassis wiring
harness connector FA-C5 (WP
0009, Figure 111) from second-
ary steering wiring harness AT-C1
(WP 0009, Figure 110) (WP
0186).
0017-37