TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0615-02 Machine Articula-
9.
Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
tion Angle Sensor Data
continuity between rear chassis
Replace secondary steering wiring
Erratic, Intermittent or Incor-
wiring harness connector FA-C23
harness (WP 0186).
rect - Continued
(WP 0009, Figure 17) terminal 4
Connect rear chassis wiring harness
and rear chassis wiring harness
connector FA-C23 (WP 0009, Figure
connector FA-C5 (WP 0009, Fig-
17) to cab lower wiring harness con-
ure 111) terminal 6.
nector P-C71 (WP 0009, Figure 18),
Resistance should be less than
and install rear bulkhead cover plate
5.0 ohms.
(WP 0266).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Proceed to step 10.
Resistance More Than 5.0 Ohms -
Replace rear chassis wiring harness
(WP 0188).
Connect secondary steering harness
connector AT-C3 (WP 0009, Figure
144) to left articulation angle position
sensor (WP 0009, Figure 145) (WP
0257).
Connect cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to Implement 1 ECM J1 (WP
0009, Figure 69) (WP 0268).
Proceed to step 10.
10. Connect MSD (WP 0006). Select
0615-02 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
0615-02 is active.
diagnostic code.
0615-02 Code Not Active - Trouble-
shooting complete.
Test Step 5. Check Sensor.
1. Install a jumper wire between har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal A and termi-
nal C.
2. Using MSD (WP 0006), verify
0615-02 Code Active - Proceed to
0615-02 is active.
step 3.
0615-02 Code Not Active - Proceed
to Test Step 6.
3. Remove jumper wire from har-
ness connector AT-C3 (WP 0009,
Figure 144) terminal A and termi-
nal C.
0017-38