TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0070-03 Parking Brake
6. Using MSD (WP 0006), select
0070-03 Code Active - Repeat trou-
bleshooting code from the beginning.
Switch Voltage Above Nor-
Trans/Chassis 120M ECM and
mal - Continued
verify 0070-03 is active.
0070-03 Code Not Active - Trouble-
shooting complete.
System Response:
0070-04 Parking Brake
Switch Voltage Above Nor-
ECM will log diagnostic code.
mal
Test Step 1. Test Parking Brake
Switch Control.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
1. Connect MSD (WP 0006). Select
Trans/Chassis 120M ECM and
verify 0070-04 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112).
4. Position parking brake switch in
the OFF position (TM 5-3805-
293-10).
5. Using digital multimeter, test for
Continuity - Proceed to step 8.
continuity between harness con-
No Continuity - Proceed to step 6.
nector FA-C21 (WP 0009, Figure
124) terminal 38 and machine
ground. There should be no conti-
nuity.
6. Position parking brake switch in
the ON position (TM 5-3805-293-
10).