TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0096-03 Fuel Level Sensor
5. Disconnect harness connector
Voltage Above Normal -
FA-C22 (WP 0009, Figure 47)
Continued
from harness connector P-C69
(WP 0009, Figure 46).
6. Disconnect harness connector U-
C8 (WP 0009, Figure 206) from
harness connector CF-C1 (WP
0009, Figure 205).
7. Using digital multimeter, test for
Continuity - Replace lower cab wiring
harness (WP 0266).
continuity between harness con-
nector P-C69 (WP 0009, Figure
Connect harness connector CF-C3
46) terminal 1 and all other termi-
(WP 0009, Figure 203) to fuel level
nals on P-C69 and to machine
sensor (WP 0009, Figure 204) (WP
ground. Resistance should be
0196).
less than 5.0 ohms.
Connect harness connector U-C8
(WP 0009, Figure 206) to harness
connector CF-C1 (WP 0009, Figure
205).
Connect harness connector FA-C20
(WP 0009, Figure 113) to transmis-
sion ECM J1 (WP 0009, Figure 112)
(WP 0137).
Proceed to step 8.
No Continuity - Replace front lighting
harness (WP 0196).
Connect harness connector FA-C20
(WP 0009, Figure 113) to transmis-
sion ECM J1 (WP 0009, Figure 112)
(WP 0137).
Connect harness connector FA-C22
(WP 0009, Figure 47) to harness con-
nector P-C69 (WP 0009, Figure 46),
and install rear bulkhead cover plate
(WP 0266).
Proceed to step 8.
8. Using MSD (WP 0006), select
0096-03 Code Active - Repeat trou-
Trans/Chassis 120M ECM and
bleshooting code from the beginning.
verify 0096-03 is active.
0096-03 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test Fuel Level Sensor
Ground Circuit.
1. Remove rear front frame cover
(WP 0224).
0016-21