TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0070-03 Parking Brake
6. Using digital multimeter, test for
Continuity - Replace lower cab wiring
Switch Voltage Above Nor-
continuity between harness con-
harness (WP 0266).
mal - Continued
nector PF-C1 (WP 0009, Figure
Proceed to step 7.
45) terminal 7 and terminal 8.
No Continuity - Replace instrument
Resistance should be less than 5.0
panel wiring harness (WP 0276).
Ohms.
Connect harness connector FA-C22
(WP 0009, Figure 47) to harness con-
nector P-C69 (WP 0009, Figure 46),
and install rear bulkhead cover plate
(WP 0266).
Connect harness connector FA-C21
(WP 0009, Figure 124) to transmis-
sion ECM J2 (WP 0009, Figure 112).
Proceed to step 7.
7. Using MSD (WP 0006), select
0070-03 Code Active - Repeat trou-
Trans/Chassis 120M ECM and
bleshooting code from the beginning.
verify 0070-03 is active.
0070-03 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test Parking Brake
Switch ON Circuit.
1. Connect harness connector PF-
C6 (WP 0009, Figure 201) to
parking brake switch (WP 0276).
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
2. Remove rear bulkhead cover
plate (WP 0266).
3. Disconnect harness connector
FA-C22 (WP 0009, Figure 47)
from harness connector P-C69
(WP 0009, Figure 46).
4. Using digital multimeter, test for
Continuity - Replace rear chassis
continuity between harness con-
wiring harness (WP 0188).
nector P-C69 (WP 0009, Figure
No Continuity - Proceed to step 5.
46) terminal 59 and machine
ground.
Resistance should be less than 5.0
ohms.
0016-13