TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0517-04 All-Wheel Drive
5. Using the MSD (WP 0006), select
0517-04 Code Active - Repeat trou-
(AWD) Switch Voltage Below
All Wheel Drive 120M and verify
bleshooting code from the beginning.
Normal - Continued
0517-04 is not active.
0517-04 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test F748-OR Creep
Mode Circuit for Short to Other
AWD Circuits in Cab Lower Wiring
Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
3. Disconnect cab lower wiring P-
C37 harness connector (WP
0009, Figure 55) from AWD ECM
J2 (WP 0009, Figure 56).
4. Using a digital multimeter, test for
No Continuity - Proceed to step 5.
continuity between P-C35 termi-
Continuity - Replace cab lower wiring
nal 33 and all other circuits in P-
harness (WP 0266).
C35 (WP 0009, Figure 53). There
Connect R-C16 (WP 0009, Figure 66)
should be no continuity.
on AWD mode switch connector (WP
0009, Figure 67) (WP 0275).
Proceed to step 7.
5. Using a digital multimeter, test for
No Continuity - Proceed to step 6.
continuity between P-C35 termi-
Continuity - Replace cab lower wiring
nal 33 (WP 0009, Figure 53) and
harness (WP 0266).
all circuits in P-C37 (WP 0009,
Connect R-C16 (WP 0009, Figure 66)
Figure 55). There should be no
on AWD mode switch connector (WP
continuity.
0009, Figure 67) (WP 0275).
Proceed to step 7.
6. Using a digital multimeter, test for
No Continuity - Proceed to Test Step
continuity between P-C35 termi-
4.
nal 33 (WP 0009, Figure 53) and
Continuity - Replace cab lower wiring
ground. There should be no conti-
harness (WP 0266).
nuity.
Connect R-C16 (WP 0009, Figure 66)
on AWD mode switch connector (WP
0009, Figure 67) (WP 0275).
Proceed to step 7.
0013-28