TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0517-03 All-Wheel Drive
Test Step 10. Test A201-BK
(AWD) Switch Voltage Above
Unswitched Battery (-) Circuit in
Normal - Continued
Cab Lower Wiring Harness for High
Resistance or Open.
1. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
sure resistance between P-C3 ter-
Connect P-C3 (WP 0009, Figure 34)
minal 39 (WP 0009, Figure 34)
on R-C1 (WP 0009, Figure 33) (WP
and ground.
0266).
Connect R-C16 (WP 0009, Figure 66)
on AWD mode switch connector (WP
0009, Figure 67) (WP 0275).
Proceed to step 2.
Resistance 5.0 Ohms or Greater -
Replace cab lower wiring harness
(WP 0266).
Connect R-C16 (WP 0009, Figure 66)
on AWD mode switch connector (WP
0009, Figure 67) (WP 0275).
Proceed to step 2.
2. Using the MSD (WP 0006), select
0517-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0517-03 is not active.
0517-03 Code Not Active - Trouble-
shooting complete.
System Response:
0517-04 All-Wheel Drive
(AWD) Switch Voltage Below
All-Wheel Drive (AWD) Electronic
Normal
Control Module (ECM) will log a diag-
nostic code and a warning will appear
on the messenger while the diagnos-
tic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for Shorted AWD
Mode Switch.
1. Connect MSD (WP 0006). Select
All Wheel Drive 120M and verify
0517-04 is active.