TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0517-03 All-Wheel Drive
4. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
(AWD) Switch Voltage Above
sure resistance between R-C1
Proceed to step 5.
Normal - Continued
terminal 38 (WP 0009, Figure 33)
Resistance 5.0 Ohms or Greater -
and R-C16 terminal 3 (WP 0009,
Replace cab upper wiring harness
Figure 66).
(WP 0265).
Proceed to step 6.
5. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
sure resistance between R-C1
Proceed to Test Step 7.
terminal 37 (WP 0009, Figure 33)
Resistance 5.0 Ohms or Greater -
and R-C16 terminal 4 (WP 0009,
Replace cab upper wiring harness
Figure 66).
(WP 0265).
Proceed to step 6.
6. Using the MSD (WP 0006), select
0517-03 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0517-03 is not active.
0517-03 Code Not Active - Trouble-
shooting complete.
Test Step 7. Test AWD Mode Cir-
cuits in Cab Lower Wiring Harness
for High Resistance or Open.
1. Disconnect cab lower wiring har-
ness connector P-C35 (WP 0009,
Figure 53) from AWD ECM J1
(WP 0009, Figure 54) (WP 0270).
2. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms on
sure resistance between P-C3 ter-
All Test Points - Proceed to step 3.
minal 51 (WP 0009, Figure 34)
Resistance 5.0 Ohms or Greater -
and P-C35 terminal 33 (WP 0009,
Replace cab lower wiring harness
Figure 53).
(WP 0266).
Connect R-C16 (WP 0009, Figure 66)
on AWD mode switch connector (WP
0009, Figure 67) (WP 0275).
Proceed to step 5.
3. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms on
sure resistance between P-C3 ter-
All Test Points - Proceed to step 4.
minal 38 (WP 0009, Figure 34)
Resistance 5.0 Ohms or Greater -
and P-C35 terminal 34 (WP 0009,
Replace cab lower wiring harness
Figure 53).
(WP 0266).
Connect R-C16 (WP 0009, Figure 66)
on AWD mode switch connector (WP
0009, Figure 67) (WP 0275).
Proceed to step 5.
0013-23