TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0517-03 All-Wheel Drive
5. Using a digital multimeter, mea-
Voltage OK (13 0.2 Volts) - Pro-
ceed to step 6.
(AWD) Switch Voltage Above
sure for voltage between R-C16
Normal - Continued
terminal 2 (WP 0009, Figure 66)
Voltage Not OK (Greater than 13.2
and ground.
Volts) - Proceed to Test Step 6.
6. Using a digital multimeter, mea-
Voltage OK (13 0.2 Volts) - Pro-
ceed to step 7.
sure for voltage between R-C16
terminal 3 (WP 0009, Figure 66)
Voltage Not OK (Greater than 13.2
and ground.
Volts) - Proceed to Test Step 6.
7. Using a digital multimeter, mea-
Voltage OK (13 0.2 Volts) - Pro-
sure for voltage between R-C16
ceed to Test Step 2.
terminal 4 (WP 0009, Figure 66)
Voltage Not OK (Greater than 13.2
and ground.
Volts) - Proceed to Test Step 6.
Test Step 2. Test Unswitched Bat-
tery (-) Circuit Resistance in Cab
Upper and Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
Resistance Less Than 5.0 Ohms -
2. Using a digital multimeter, mea-
Proceed to Test Step 3.
sure resistance between R-C16
terminal 1 (WP 0009, Figure 66)
Resistance 5.0 Ohms or Greater -
and ground.
Proceed to Test Step 8.
Test Step 3. Test F747-OR Creep
Mode Circuit Function in AWD
ECM.
1. Connect jumper wire between R-
C16 terminal 2 and terminal 1
(WP 0009, Figure 66).
2. Turn battery disconnect switch
and ignition switch to the ON posi-
tion.
3. Check for Active code 0517-03 in
Code 0517-03 Becomes Inactive -
All Wheel Drive 120M ECM (WP
Proceed to Test Step 4.
Code 0517-03 Remains Active -
Replace AWD ECM (WP 0270).
Remove jumper wire from R-C16 ter-
minal 2 and terminal 1 (WP 0009, Fig-
ure 66).
Connect R-C16 (WP 0009, Figure 66)
on AWD mode switch connector (WP
0009, Figure 67) (WP 0275).
Proceed to step 4.
0013-20