TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0168-02 Electrical System
5. Using a digital multimeter, mea-
Resistance 5.0 Ohms or Greater -
Voltage Erratic, Intermittent,
sure resistance between P-C35
Replace cab lower wiring harness
(WP 0266).
or Incorrect - Continued
terminal 57 (WP 0009, Figure 53)
and ground.
Proceed to step 6.
Resistance Less Than 5.0 Ohms -
Replace AWD ECM (WP 0270).
Proceed to step 6.
6. Using the MSD (WP 0006), select
0168-02 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0168-02 is not active.
0168-02 Code Not Active - Trouble-
shooting complete.
0517-03 All-Wheel Drive
System Response:
(AWD) Switch Voltage Above
All-Wheel Drive (AWD) Electronic
Normal
Control Module (ECM) will log a diag-
nostic code and a warning will appear
on the messenger while the diagnos-
tic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test Voltage of AWD
Mode Circuits in Cab Upper Wiring
Harness.
1. Connect MSD (WP 0006). Select
All Wheel Drive 120M and verify
0517-03 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Disconnect cab upper wiring R-
C16 harness connector (WP
0009, Figure 66) from AWD mode
switch connector (WP 0009, Fig-
ure 67).
4. Turn battery disconnect switch
and ignition switch to the ON posi-
tion.