POWER TRAINDISASSEMBLY AND ASSEMBLYTM 5-3805-263-14&P-2TRANSMISSION HYDRAULIC CONTROL VALVES8. Put modulating control valve (21) in posi-tion on manifold (22).9. Put valve spools (30) and (37) in position inthe differential control valve. Put springs(28) and (40) in position on the spools.10. Put spring (34) in position in valve spool(24). Put spool (24) into position in thevalve.11. Install O-ring seal (44) on the plug.12. Put washer (35), spring (36), and plug (42)in position in the valve.13. Put valve spool (26) into position in sleeve(29).14. Put slug (33) and two springs (31) in posi-tion in piston (32).15. Put piston (32) and the springs into positionin the valve.16. Put sleeve (29) and the valve spool into po-sition in the valve. Put spring (27) in posi-tion on the sleeve.17. Put stop (39) into position in the valve. In-stall dowel (38) that holds the stop.18. Install O-ring seal (25) in cover (23). Putcovers (23) and (41) in position on thevalve. Install bolts (43) that hold the twocovers. Tighten bolts (43) to a torque of22 ± 3 lb.ft. (3.0 ± 0.4 mkg). Install theeight dampers and the dowels.19. Put differential control valve (45) in posi-tion on the modulating control valve.2-121
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
