ENGINE DISASSEMBLY AND ASSEMBLY TM   5-3805-263-14&P-2 CRANKSHAFT  REAR  SEAL  AND  WEAR  SLEEVE REMOVE  CRANKSHAFT  REAR  SEAL AND  WEAR  SLEEVE Tools  Needed A B C 1P3075 Puller   Assembly 1 5P7312 Distorter 1 5P7313 Ring 1 start by: a)  remove  flywheel NOTE: When a replacement of the rear seal is made, a replacement  of  the  wear  sleeve  is  to  be  made  also. 1. Remove the crankshaft rear seal with tool (A). 2. Install tool (C) in the rear seal bore. 3.  Install  tool  (B)  between  tool  (C)  and  the  wear sleeve.  Turn  tool  (B)  until  the  edge  of  the  tool makes  a  flat  place  (crease)  in  the  wear  sleeve.  Do this  in  two  or  more  places  until  the  wear  sleeve  in loose. 4. Remove tool (C) and the wear sleeve by hand. INSTALL CRANKSHAFT REAR SEAL AND  WEAR  SLEEVE Tools  Needed A 9S8871 Locator 1 9S8858 Nut 1 9S8890 Bolt 3 5P7298 Installer 1 1. Install the crankshaft rear seal and wear sleeve with  tooling  (A)  as  follows: a) Put locator (1) in position on the crankshaft and install the three bolts that hold it in place. b)   Put  clean  engine  oil  on  the  seal  lip  of  seal  (6) and  on  the  outside  diameter  of  wear  sleeve (2). c)  Install  seal  (6)  on  wear  sleeve  (2)  from  the end of the wear sleeve that has the bevel on the  outside  diameter.  Make  sure  the  lip  of  the seal  is  toward  the  inside  of  the  engine  and  the bevel  that  is  on  the  outside  diameter  of  the wear  sleeve  is  toward  the  outside  of  the  en- gine  when  installed. d)   Use 6V1541 Quick Cure Primer to clean the outside  diameter  of  the  crankshaft  flange  (3) and  the  inside  diameter  of  wear  sleeve  (2). e)   Put  9S3265  Retaining  Compound  on  the  out- side  diameter  of  crankshaft  flange  (3)  and  the inside  diameter  of  wear  sleeve  (2). NOTE: Make sure the lip of the seal is toward the inside of  the  engine  and  the  outside  diameter  bevel  of  the  wear sleeve  is  toward  the  outside  of  the  engine. f) Put wear sleeve (2) with seal (6) on locator (1).  Put  installer  (4)  on  locator  (1)  and  install nut (5). Rut ‘lubrication on the face of the washer  and  the  nut. g)  Tighten  nut  (5)  until  installer  (4)  comes  in contact  with  locator  (1). h) Remove tooling (A) and check the wear sleeve  and  seal  for  correct  installation. end by: a)  install  flywheel 1-215