ENGINE
DISASSEMBLY AND ASSEMBLY
TM 5-3805-263-14&P-2
PISTON COOLING ORIFICES
REMOVE AND INSTALL PISTON COOLING
ORIFICES
Tools Needed
A
FT1542
Orifice Driver
1
start by:
a) remove crankshaft and gear
NOTE: The piston cooling orifices are installed in
the No. 2 and 4 main bearing bosses in the cylinder
block.
1. Use a soft punch to remove the orifices from the
cylinder block.
2. Use tool (A) to install the orifices in main bear-
ing bosses No. 2 and 4 until they are against the
counterbore. Be sure the orifices are open after
they are installed.
end by:
a) install crankshaft and gear
1-220
