TIMING GEAR COVER

TM-5-3805-263-14P-2 Grader Heavy Road Motorized Type I Nonsectionalized Type II Sectionalized Manual
Page Navigation
183

ENGINE DISASSEMBLY AND ASSEMBLY TM 5-3805-263-14&P-2 TIMING GEAR COVER REMOVE TIMING GEAR COVER start by: a) remove air compressor b) remove alternator c) remove water pump d) remove fan drive e) remove engine front support 1. Remove the bolts and disconnect fuel line clips from the engine. 2. Disconnect fuel line (2) from the fuel priming pump and move it away from the front cover. 3. Install spacers (8) to each side of engine between oil pan plate and the engine block as shown. CAUTION Use care when the trunnion is removed and installed to prevent damage to the crankshaft front seal. 4. Remove bolts (7) trunnion (6) and the O-ring seal from the front cover. 5. Remove bolts (9) cover (10) and the gasket from the timing gear plate. NOTE: Put marks on all the bolts and their location on timing gear cover (11) before removal. For infor- mation about bolts at locations (X), see next page. 6. Remove bolts (11) and timing gear cover (12) from the engine. 7. Clean the old gasket from the contact surfaces of the timing gear cover and timing gear plate. 1-188

Privacy Statement
Press Release
Contact