ENGINETIMING GEAR COVERDISASSEMBLY AND ASSEMBLYTM 5-3805-263-14&P-2INSTALL TIMING GEAR COVER1. Install a new gasket on the timing gear plate.Cut the gasket even with the bottom face of thecylinder block. Put 5H2471 Gasket Cement onthe bottom of the gasket where the gasketmakes contact with the gasket for the oil panplate.2. Put timing gear cover (1) in position on thetiming gear plate and install the bolts that holdit in place.NOTE: Tighten bolts (X) to a torque of 23 ± 4 N·m(17 ± 3 lb. ft.) For location of bolts (X) see picture onpreceding page.3.4.5.6.Put the O-ring seal and cover (2) in position onthe timing gear plate with the bolts that holdthem.Be sure the O-ring seal is in position on trun-nion (3). Put trunnion (3) in position on thetiming gear cover and install bolts (5). Tightenthe bolts to a torque of 135 ± 15 N·m (100 ±11 lb. ft.).Remove spacers (4) from between the oil panplate and the engine block.Connect fuel line to the fuel priming pumpand clips that hold the fuel line to the engine.end by:a) install engine front supportb) install fan drivec) install water pumpd) install alternatore) install air compressor1-189
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
