ENGINE CONT. - TM-5-3805-263-14P-2

TM-5-3805-263-14P-2 Grader Heavy Road Motorized Type I Nonsectionalized Type II Sectionalized Manual
Page Navigation
181

ENGINE DISASSEMBLY AND ASSEMBLY TM 5-3805-263-14&P-2 ENGINE 7. Install fuel lines (11) to the fuel injection pump. install fuel line (9) to the fuel filter. 8 Put clips (10) in position and install bolt to hold it on the oil filler tube. 9. Put air compressor line clip (14) in position on the flywheel housing and install bolt to hold clip in place. 10. Connect two transmission oil lines (13) on the transmission oil cooler. 11. Connect air compressor line (16) to fitting and oil pressure line to cylinder block fitting (12). 12. Install three wires (15) from harness on switch. 13. Put two clips (I 9) used to hold two hose assem- blies in position and install bolts to hold them. 14. Put tube (17) in position on the machine. In- stall the hoses (21) and theclamps (18) on each end of the tube. 15. Install clip (20) in position on the bottom of the fuel tank. 16. Install wire on the water temperature switch (25). 17. 18. Install support (22) on cylinder head and install the water temperature gauge sending unit (23) in the cylinder head. Connect hose assembly (24) to the air compres- sor. 1-186

Privacy Statement
Press Release
Contact