TM 5-3805-263-14&P-3
DISASSEMBLY AND ASSEMBLY
ROLLOVER PROTECTIVE STRUCTURE (ROPS)
INSTALL ROLLOVER PROTECTIVE
STRUCTURE
1
Remove front (1) and rear (2) platform guard
groups. Remove any shipping braces from the
hydraulic tank, if present.
2.
Position the ROPS on the vehicle. Leave lifting
hoist in position until ROPS is completely installed.
3
Secure two support assemblies (3) with mounting
bolts, washers, lockwashers, mounts and nuts
(4). Install shims as required to level ROPS.
4
Apply 2P2506 Lubricant on the washer faces and
bolt threads (5). Position the ROPS on the vehicle
and install six bolts and washers (5) that secure
the ROPS (three bolts are used on each side).
Tighten bolts to a torque of 525 + 20 lb ft. (72.6 +
34 N.m).
5
Install bolts (6) that secure the ROPS to the
hydraulic tank (7).
6
Install two angles (8) (one on each side) and the
floormat.
4-84
