REAR AXLE MAINTENANCE. (cont.) - TM-5-3805-261-34

REAR AXLE MAINTENANCE. (cont.) - TM-5-3805-261-34_983

REAR AXLE MAINTENANCE. (cont.) - TM-5-3805-261-34_985

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
937

TM 5-3805-261-34 REAR AXLE MAINTENANCE. (cont) 14-17. Differential Assembly. (Sheet 8 of 12) ASSEMBLY (cont) 5. Using clean engine oil SAE 30, lubricate lips of new seals (36 and 35) and install items 37 thru 35 as an assembly on housing (38, Figure 14-131). NOTE Dowels must protrude 0.141 to 0.149 inch from surface of housing to engage slots in washer. 6. Install two dowels (34). 7. Turn over items 38 thru 33 as an assembly and install on items 43 thru 39 as an assembly (Figure 14-130). 8. Install 18 washers (32) and bolts (31). Tighten 18 bolts (31) to 175 to 195 ft-lb torque. 9. If absence of ball (30) was noted during disassembly, install new ball (30), peening over edges of housing (38) to be sure ball is securely retained. 10. Heat cone bearing (29) in engine oil SAE 30 to 175 degrees F and install. 11. Install ring (26), two rings (25) and cup (24) to cage (28, Figure 14-129). 12. Install nut (23). 13. If absence of ball (27) was noted during disassembly, install new ball (27) in cage (28), peening over edges of cage to be sure ball is securely retained. Figure 14-130. Figure 14-131. Figure 14-129. Go to Sheet 9 14-96

Privacy Statement
Press Release
Contact