TM 5-3805-261-34
REAR AXLE MAINTENANCE. (cont)
14-17. Differential Assembly. (Sheet 6 of 12)
DISASSEMBLY (cont)
15. Using puller attachment, puller
group, two legs, step plate, four
step plates, two nuts and pump
group, remove cone bearing (29,
Figure 14-130).
16. Check for presence of ball (30)
in housing (38). If ball is
present, do not remove. If ball
is missing, make note to install
new ball (30) during assembly.
17. Remove 18 bolts (31) and washers
(32) from housing (38).
18. Remove items 33 thru 38 as an
assembly (Figure 14-131) and turn
upside down.
19. Remove washer (33), two dowels
(34) and items 35 thru 37 as an
assembly from housing (38).
20. Remove and discard seals (35 and
36) from piston (37, Figure
14-132).
21. Remove ring gear (39), seven
discs (40), eight discs (41) and
disc (42) from housing (43,
Figure 14-133).
Figure 14-130.
Figure 14-131.
Figure 14-132.
Figure 14-133.
Go to Sheet 8
14-94