ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_885

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_887

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
839

TM 5-3805-261-34 ENGINE MAINTENANCE. (cont) 13-10. Crankshaft Front and Rear Seals and Wear Sleeves. (Sheet 4 of 6) CLEANING Clean all parts. Refer to Chapter 2. INSPECTION Inspect all parts. Refer to Chapter 2. INSTALLATION 1. Using clean engine oil, lubricate outside diameter of rear seal (6) lip and wear sleeve (7, Figure 13-58). 2. Install rear seal (6) on bevel end (outside diameter) of wear sleeve (7). Make sure the lip of rear seal (6) is toward inside of engine and outside bevel diameter of wear sleeve (7, Figure 13-59) is toward outside of engine. 3. Position locator (Figure 13-60) on rear flange of crankshaft. 4. Install three bolts securing locator. 5. Apply quick cure primer to outside diameter of crankshaft flange and inside diameter of wear sleeve (7). 6. Apply retaining compound to outside diameter of crankshaft flange and inside diameter of items 7 and 6 as an assembly. 7. Position items 7 and 6 as an assembly and slide on locator. Make sure lip of rear seal (6) is toward engine and bevel of wear sleeve (7) is away from engine. Go to Sheet 5 13-60 Figure 13-58. Figure 13-59. Figure 13-60.

Privacy Statement
Press Release
Contact