TM 5-3805-261-34
ENGINE MAINTENANCE. (cont)
13-10.
Crankshaft Front and Rear Seals and Wear Sleeves. (Sheet 6 of 6)
INSTALLATION (cont)
17. Install bolt on installer and
tighten until inside surface on
installer comes in contact with
end of crankshaft (Figure 13-65).
18. Remove bolt and installer (Figure
13-66).
19. Install hub (3), washer (2) and
bolt (1, Figure 13-55) to front
of crankshaft. Tighten bolt (1)
to 230 ft-lb torque.
NOTE
Return 13OG Grader to
original equipment condition.
End of Task
13-62
Figure 13-65.
Figure 13-66.
Figure 13-55.