ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_886

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_888

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
840

TM 5-3805-261-34 ENGINE MAINTENANCE. 13-10. Crankshaft Front and bar Seals and Wear Sleeves. (Sheet 5 of 6) INSTALLATION 8. Position installer on locator behind items 7 and 6 as an assembly. 9. Apply clean engine oil to contacting surfaces of nut and washer. 10. Install and tighten nut and washer on installer until installer comes in contact with locator and pushes items 7 and 6 as an assembly on crankshaft flange (Figure 13-61). 11. Remove nut and washer, installer, locator and three bolts (Figure 13-62) from crankshaft. 12. Apply clean engine oil to lip of seal (4) and outside diameter of wear sleeve (5, Figure 13-63). 13. Apply quick cure primer to outside diameter of crankshaft and inside diameter of items 5 and 4 as an assembly (Figure 13-64). 14. Apply retaining compound to outside diameter of crankshaft and items 5 and 4 as an assembly. NOTE Make sure lip of seal is toward engine and beveled end of sleeve is away from engine. 15. Position items 5 and 4 as an assembly on crankshaft. 16. Position installer on crankshaft. Go to Sheet 6 13-61 Figure 13-62. Figure 13-61. Figure 13-63. Figure 13-64.

Privacy Statement
Press Release
Contact