ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_884

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_886

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
838

TM 5-3805-261-34 ENGINE MAIENANCE. 13-10. Crankshaft Front and Rear Seals and Wear Sleeves. (Sheet 3 of 6) REMOVAL NOTE When the front seal is replaced, the wear sleeve must be replaced, also. 1. Using puller assembly, remove seal (4, Figure 13-56) from front of crankshaft. 2. Install ring into seal (4) bore in trunnion. 3. Insert distorter between wear sleeve (5) and ring. 4. Turn until distorter creases wear sleeve (5). Do this in two or more places until wear sleeve (5) is loose. 5. Remove distorter and wear sleeve (5) by hand. 6. Remove rear seal (6) and wear sleeve (7, Figure 13-57) from rear-flange on crankshaft. Repeat steps 5 thru 9. Go to Sheet 4 13-59 Figure 13-55. Figure 13-56. Figure 13-57.

Privacy Statement
Press Release
Contact