TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE. (cont)
10-20.
Scarifier Cylinder. (Sheet 5 of 5)
INSTALLATION (cont)
7.
Install new preformed packing (7)
and connector (6, Figure 10-147).
8.
Connect hose assembly (5).
9.
Install new preformed packing (4)
and elbow (3).
10. Connect hose assembly (2).
11. Install new tie (1) on cylinder
(14) to secure hose assembly (2).
WARNING
Only a qualified operator may
perform the next steps.
Failure to follow this
procedure may cause INJURY.
If you are injured, seek
medical aid immediately.
12. Start engine. Refer to TM 5-
3805-261-10.
13. Operate scarifier control and
move through at least five full
movements of travel to bleed air
from system.
14. Stop engine.
15. Inspect hose assemblies (5 and
2), fittings and cylinder (14) at
front frame for leaks.
NOTE
Return 130G Grader to
original equipment condition.
End of Task
10-120
Figure 10-147.
