TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE.
10-20.
Scarifier Cylinder. (Sheet 4 of 5)
INSTALLATION
1.
Using suitable driver and hammer,
install four new seals (12,
Figure 10-149) in eye of rod with
lips toward outside. Lips must
be approximately even with outer
surface of rod eye.
2.
Using suitable driver and press,
install two bearings (13). if
removed. Two bearings (13)
contact two new seals (12).
NOTE
Repeat steps 1 and 2 for new
seals and bearings at
opposite end of cylinder.
3.
Attach hoist and sling to items
14 thru 12 as an assembly (Figure
10-148).
4.
Using hoist and sling, position
items 14 thru 12 as an assembly
in mounting brackets. Remove
slack from sling.
5.
Install two pins (11), locks
(10), four washers (9) and bolts
(8). When installing two pins
(11), use care not to damage four
new seals (12) or two bearings
(13).
6. Remove hoist and sling.
Go to Sheet 5
10-119