TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE. (cont)
10-20.
Scarifier Cylinder. (Sheet 3 of 5)
REMOVAL (cont)
7.
Remove four bolts (8), four
washers (9) and two locks (10,
Figure 10-148).
8.
Remove two pins (11).
9.
Remove items 12 thru 14 as an
assembly from mounting brackets
and lower onto suitable repair
stand or work bench with padding.
10. Remove hoist and sling.
11. Remove four seals (12) being
careful not to damage bearings
(13, Figure 10-149). Discard
four seals (12).
CAUTION
Removal of bearings from
cylinder can cause
destruction of bearings.
Remove bearings only if
inspection indicates
replacement is necessary.
12. Inspect two bearings (13).
Replace if cracked, broken,
distorted, grooved or worn.
13. Using suitable driver and press,
remove two bearings (13), if
necessary, from cylinder (14).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter
2.
Figure 10-148.
Figure 10-149.
Go to Sheet 4
10-118