HYDRAULIC SYSTEM MAINTENANCE. (cont)

HYDRAULIC SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_720

HYDRAULIC SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_722

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
674

TM 5-3805-261-34 HYDRAULIC SYSTEM MAINTENANCE. (cont) 10-16. Tip Blade Cylinder. (Sheet 2 of 6) REMOVAL NOTE All hose and tube assemblies must be tagged before disconnecting to aid in installation. Cap all hose and tube ends to prevent contamination. 1. Disconnect hose assembly (1, Figure 10-126) from blade tip on circle assembly. 2 Remove connector (2)and preformed packing (3). Discard preformed packing (3). 3. Disconnect hose assembly (4). 4. Remove elbow (5) and preformed packing (6). Discard preformed packing (6). WARNING Weight of blade tip cylinder is approximately 50 pounds. Use adequate hoist and sling for lifting. Failure to follow this procedure may cause INJURY. If you are injured, seek medical aid immediately. 5. Attach hoist and sling to cylinder (16). Remove slack from sling. 6. Remove and discard cotter pin (7). 7. Remove pin (8) and two spacers (9). Prevent spacers (9) from falling when removing pin (8). 8. Remove bolt (10). 9. Remove pin (11) Figure 10-126. Go to Sheet 3 10-92

Privacy Statement
Press Release
Contact