TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE. (cont)
10-4.
Pump Assembly. (Sheet 12 of 23)
ASSEMBLY
1.
Put a small amount of hydraulic
fluid on all parts.
2.
Install dowel (129) on swash-
plate (132, Figure 10-46).
3.
Lower temperature of two bearing
cups (131) an install in
swashplate (132).
4.
Install two stops (130).
5.
Install plate (128) in swashplate
(132) with hole in plate (128) in
alinement with dowel (129).
6.
Lower temperature of bearing cup
(117) and install in body (118,
Figure 10-47).
7.
Install new preformed packing
(110), bolt (109) and nut (108)
in body (118). Bolt (109) is the
maximum stop bolt and must be
installed in the same hole from
which it was removed.
8.
Install new preformed packing
(107), bolt (106) and nut (105).
Bolt (106) is the minimum stop
bolt and must be installed in the
same hole from which it was
removed.
9.
Install swashplate (132) in body
(118).
Go to Sheet 13
10-26
Figure 10-47.
Figure 10-46.
